Hoopla!!

The staff at Always Quilting recently discussed using embroidery and quilting frames to display textile work. Embroidery and stitcheries, applique, pieced items and quilting, even a pretty piece of fabric can all be displayed this way. A quick internet search gives you lots of inspiration! Indeed, I was inspired and have since made a couple of items which are displayed in inexpensive embroidery hoops.

For my first piece, I decided to engage in some English paper piecing and fussy cutting and make a small companion piece for a mini quilt made last year and which I blogged about in a previous post. https://alwaysquilting.wordpress.com/2014/11/28/always-playing…-fussy-cutting/  You might recall that there was not much fabric left, but certainly sufficient for my purpose.

sewing- blog Nov 2014 058

Plenty of holes, but still enough fabric for my project!

I used 4x 2-inch clamshells and fussy-cut my fabric, with a small circle as the centre. There are many methods of preparing your English paper pieces, from tacking, to glue-basting, to fusible papers. I discuss one method here. https://alwaysquilting.wordpress.com/2013/02/22/english-paper-…agons-and-more/  When using clamshells, I prefer to tack the paper in place as this gives me greatest control over the curve, ensuring it is nice and smooth. When it is tacked into place I give it a good press.

Hoopla blog 015-crop

Tacking the fabric onto the clamshell paper.

Once I had made my clamshells I appliqued them onto my background fabric using Aurifil Cotton Mako 50. As you can see in the photo, I left plenty of fabric around the edges. I then took my little hoop, in this case 5 inches in diameter, and centred my design in it. When I was happy with its placement I tightened the screw so that the work was tensioned with no wrinkles.

 

Hoopla blog 004

Ensure the item is centred in the hoop.

I trimmed the background fabric to a border of about 1 1/2 inches.

Hoopla blog 005-crop

Trimming excess fabric to 1 1/2 inches.

I took a strong thread (Aurifil Cotton Mako 28) and ran a gathering stitch around the perimeter. To make this job easier I did not cut my thread off the spool, but used it directly from the spool. This way could adjust it as required, and I didn’t run the risk of miscalculating the length of cotton I needed, or of accidentally pulling the gathers out. When I had the gathers sitting as I wanted, I cut the threads leaving a tail, then tied them in a reef knot to secure them.

page

Gathering the background fabric behind the hoop.

To cover the back of the hoop I cut a circle of felt, using the hoop as a template for the circle. I wanted the felt to fit just to the edge of the blue background fabric, but inside hoop. Finally I stitched the felt in place again using a strong thread, Aurifil Cotton Mako 28. I used an overstitch going from the felt out towards the edge of the hoop as shown in the photo, and I ensured that each bite into the felt was about 3mm and went into the blue background fabric each time.

Hoopla blog 011-crop

Stitching the felt back into place.

And my little project is finished and ready to hang on the wall!

Hoopla blog 016-crop

My little hanging all ready to display on the wall.

In a future post, I will write about another project framed in this way.

 

Advertisements